[DesignModeler] mixing tee in ansys design modeler

tmeysam92 · April 6, 2012, 03:15

Hi guys,

I have a simple question.
How can I build a mixing tee like below figure in ansys design modeler.
I use ansys 14.
thanks in advance.

pavilion · April 6, 2012, 10:38

Hi tmeysam92
I suggest you read the "Fluid Flow and Heat Transfer in a Mixing Elbow" tutorial in the "ANSYS FLUENT 12.1 in Workbench Tutorial" and i think you will find the answer to your question
here is the link:
https://www.sharcnet.ca/Software/Fluent12/html/wbtg/node8.htm

for the internal groove you can simply use the extrude --> cut material

enjoy!!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] Connecting 3D bodies in Ansys Design Modeler	chipper	ANSYS Meshing & Geometry	4	January 25, 2018 09:45
Ansys Design modeler subtraction	natantyt	ANSYS Meshing & Geometry	5	February 11, 2017 22:02
[DesignModeler] ansys design modeler	tmeysam92	ANSYS Meshing & Geometry	0	April 5, 2012 11:28
Ansys Design Modeler complex geometry	natantyt	ANSYS Meshing & Geometry	1	October 17, 2011 08:57
Need some basic information for using Ansys Design Modeler	pradeepmash	ANSYS Meshing & Geometry	3	October 24, 2010 16:01

April 6, 2012, 10:38		#2
pavilion New Member Pavilion Join Date: Feb 2012 Posts: 7 Rep Power: 14	Hi tmeysam92 I suggest you read the "Fluid Flow and Heat Transfer in a Mixing Elbow" tutorial in the "ANSYS FLUENT 12.1 in Workbench Tutorial" and i think you will find the answer to your question here is the link: https://www.sharcnet.ca/Software/Fluent12/html/wbtg/node8.htm for the internal groove you can simply use the extrude --> cut material enjoy!!