 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Multi-size mesh generation in ANSYS 12.1 Workbench |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 6, 2012, 13:37
|
Multi-size mesh generation in ANSYS 12.1 Workbench
|
#1 |
|
New Member
Md Nazmus Sakib
Join Date: Apr 2012
Posts: 5
Rep Power: 15  |
Hello
I am working on a model of flow around a pier in a rectangular channel with two-phase air and water flow. I want to generate like 5mm mesh around the pier upto a certain area and 10mm mesh on rest of the channel. I can do it with inflation around the pier, but it goes radially around the pier. If i want it to do in irregular shape like the area of a specified rectangular within the channel; what should i do? It will be very nice to have some suggestions in that. Sakib |
|
|
|
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
| Ansys workbench CFX Mesh | Tom | ANSYS Meshing & Geometry | 22 | December 1, 2010 22:34 |
| OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 14:43 |
| Ansys 12 Workbench problem when generating volume mesh | Sveink | ANSYS | 5 | January 6, 2010 04:17 |
| Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 19:10 |
Linear Mode
