Hi
GOSH, YOU are AMAZINGLY KIND and eager to help
I really appreciate it
before I start working on a wind turbine blade I have got to simulate 3-D flow over an extruded NACA0012 profile.
Actually I've got no idea about it
If you give me the clues I'll work on it and ask u my problems
thanks very much

Hello Far,

I know this thread is pretty old, but I have one question: Which steps are necessary to apply the o-grid for the cylinder? (third screenshot, message #7)

I already made the geometry and the initial block, but there is no small cylinder-block or something else for the o-grid. What is the blocking stategy for this problem?

Thank you very much for your help!

Hello again,

I solved the issue :)