CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Edge parameters problem (

fd99 April 17, 2012 07:01

Edge parameters problem

I'm new to ICEM so please treat me kindly :)

I encountered following problem when generating the premesh:

After having generated the initia block, i splited it several times and in the end i got following configuration:

1 2
3 4
5 6

I deleted block 4, because it represents the interior of a wall, which I don't want to simulate, which gave me following config.:

1 2
5 6

I did all the assigments and when I change now the edge paratmeters of te horizontal edges of block 6, ICEM channges the node-number of block 2 accordingly. I turned of the 'copy parameters' buton, but it still won't help.

How do I change the horizontal node number of block 6 without changing the number of nodes of block 2?

Thank you very much,


Far April 17, 2012 07:05

I promise to be gentle!

delete block 4 permanently (solution taken from Simon's presentation available on ANSYS portal)

fd99 April 17, 2012 07:36

Merci beaucoup Far!

Far April 17, 2012 07:37

Far April 17, 2012 07:39

Merci beaucoup Far! = Thanks a lot Far! ;)

All times are GMT -4. The time now is 12:29.