|June 8, 2012, 14:16||
3D Mapped meshing
Join Date: Feb 2012
Posts: 24Rep Power: 7
I am trying to mesh a simple 3D rectangle. I want the middle section to have a finer mesh than the outter edges.
For 2D i used edge sizing then mapped the face. However when i try this on my 3D model it does not work.
I generate the model however i the following message:
"The following surfaces cannot be meshed with acceptable quality. Try using a different element size or virtual topology"
I would greatly appreciate any help. Or if someone can suggest another method that would also be great.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[Workbench] mapped face meshing||taw||ANSYS Meshing & Geometry||1||February 28, 2013 11:44|
|Need help in mapped meshing||leslie.lp2003||ANSYS Meshing & Geometry||0||March 26, 2010 10:45|
|[ICEM] Need help in ICEM CFD Mapped Meshing||falconf16||ANSYS Meshing & Geometry||3||February 19, 2010 15:21|
|is free meshing or mapped meshing is best for flow problems||shanu||Main CFD Forum||0||February 18, 2010 12:58|
|is free meshing or mapped meshing is best for flow problems||shanu||OpenFOAM Meshing & Mesh Conversion||0||February 18, 2010 12:56|