|
[Sponsors] |
Ansys 14 WB problem with updating design points |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 9, 2012, 11:05 |
Ansys 14 WB problem with updating design points
|
#1 |
Member
Vit Houst
Join Date: Apr 2012
Posts: 35
Rep Power: 14 |
Hello,
i wanted to compare the results from v12 to v14. I took the .cfx file from my older simulation and started a wb project from this file. When I create parameters etc and i select the cases, that I want to run, the solver wont start. When I push update all design points it says that all design points are up to date despite there is no result file at all for any of the points. The obly thing, that I can do is to start solver and solve only the dp0. Does anyone know, why this is going on and how to run the simulation? V. |
|
September 5, 2012, 11:47 |
|
#2 |
New Member
Sascha
Join Date: May 2012
Location: Germany
Posts: 14
Rep Power: 14 |
Hey vitulaaak,
I have no idea, what happens if you open your old project with the V14 ? |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to Connect Points in Design Modeler to make airfoil profile (2D) | andrew_diablo | CFX | 3 | July 7, 2017 06:23 |
ANSYS 13 problem | zona | ANSYS | 0 | December 16, 2010 07:48 |
[Other] ANSYS CFX-Meshing problem of a wind turbine blade | Zoe | ANSYS Meshing & Geometry | 1 | July 14, 2010 03:02 |
ansys problem | ENGRTAHIR | Main CFD Forum | 0 | May 11, 2010 17:29 |
Ansys 12 Workbench problem when generating volume mesh | Sveink | ANSYS | 5 | January 6, 2010 04:17 |