CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS (
-   -   Editing expressions from the command line (

Hemo September 15, 2012 16:56

Editing expressions from the command line

I want to run some parametric tests. It is a simple problem, with two parameters which are defined as expressions that I want to change. I have around three hundred combinations of the parameters to run, so I don't fancy doing it manually.

Is there a way I can run a .def file from the command line multiple times with cfxsolve , but edit the expression values?


SaschaGH September 21, 2012 10:15

Hey Hemo,

unfortunately I am not able to help you with your question exactly. But wouldn't it be easier ( if possible) to run everything within the Workbench using Design Points ? This would pretty much cover your Parameter Analysis and you wouldn't have to write many lines of script.

Hemo September 21, 2012 10:33

Hi Sascha,

Thanks for the suggestion. In the end, I exported the ccl and edited it in matlab, then ran everything from the command line.

All times are GMT -4. The time now is 11:51.