 |
 |
 |
|
|
|
[Sponsors] | ||||
April 17, 2018, 16:30
|
Negative Volume in fuel injection system
|
#1 |
|
New Member
Abhay
Join Date: Apr 2018
Posts: 1
Rep Power: 0  |
I have a combustion chamber, with a fuel injector pipe leading upto it. There are many cells with negative volume near the interface of the combustor wall and the inlet pipe.
The .blk file : https://drive.google.com/open?id=103...uVSVkn5kXy9nxD The .tin file : https://drive.google.com/open?id=11b...VAQyZJYEUWy7gw |
|
|
|
|
 |
| Tags |
| ansys, combustion chamber, icem, meshing, multiple blocks |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
| [ANSYS Meshing] Small mesh error: Zero or negative volume for elements. [Explicit dynamics] | matin | ANSYS Meshing & Geometry | 0 | September 14, 2017 20:19 |
| Problem of simulating of small droplet with radius of 2mm | liguifan | OpenFOAM Running, Solving & CFD | 5 | June 3, 2014 02:53 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
| remeshing due to negative volume error | Doginal | CFX | 1 | August 21, 2011 21:50 |
Linear Mode
