|
[Sponsors] |
October 18, 2012, 11:03 |
[icem]
|
#1 |
New Member
Join Date: Mar 2011
Posts: 20
Rep Power: 15 |
Hi at all, i try to find out an ICEM programming manual to modify its own macro.where or how can i found it? thanks
|
|
October 27, 2012, 08:55 |
|
#2 |
Senior Member
Stuart Buckingham
Join Date: May 2010
Location: United Kingdom
Posts: 267
Rep Power: 25 |
Helios,
The Programming manual gives you all the ICEM related commands to create/modify geometry, mesh and blocking. You can also use normal tcl/tk commands for things like variables and maths functions. Hope this helps, Stu |
|
October 29, 2012, 06:46 |
|
#3 |
New Member
Join Date: Mar 2011
Posts: 20
Rep Power: 15 |
thanks for your help Stu. i appreciate that too much.
Helios |
|
October 29, 2012, 08:08 |
|
#4 |
Senior Member
Stuart Buckingham
Join Date: May 2010
Location: United Kingdom
Posts: 267
Rep Power: 25 |
No problem.
Do you have a specific task you are trying to do? Post again if you need a hand. Stu |
|
October 30, 2012, 06:56 |
|
#5 |
New Member
Join Date: Mar 2011
Posts: 20
Rep Power: 15 |
i have to do a complete campaign of analysis measuring lift, drag and so on between [-5,+13] angle of attack's degrees for 3 thin airfoils. i have registered macro which create the meshes but i have to write the recoursive routine to make what i said.Sorry for my worst english but i hope i was fair.
Thanks again Helios |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Meshing Error with a Solidworks Geometry | Fractal | ANSYS Meshing & Geometry | 2 | November 12, 2019 12:59 |
[ICEM] Negative volume error in hybrid mesh | siw | ANSYS Meshing & Geometry | 4 | September 3, 2014 05:25 |
[ICEM] Octree surface mesh issue | siw | ANSYS Meshing & Geometry | 6 | February 13, 2011 12:46 |
[ICEM] Forcing surface and curve to match | sherifkadry | ANSYS Meshing & Geometry | 0 | August 27, 2010 00:28 |
[ICEM] Trying out with Hexa for a wing | siw | ANSYS Meshing & Geometry | 0 | August 26, 2010 10:13 |