CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS (
-   -   CFD Post Application Error: 'wbload' action requires parameter: 'id'. (

gusymtz November 2, 2012 09:57

CFD Post Application Error: 'wbload' action requires parameter: 'id'.

I've finished some simulations through the Fluent application in ANSYS. I wanted to transfer my results to the Results Application in Workbench. When I tried to open the application, this error came up:

'wbload' action requires parameter: 'id'.

Thanks to this, I have not been able to process the results I got from Fluent.

Any recommendation or thoughts on this?



Soheyl.ysf May 7, 2014 14:58

same problem
Hi Gustavo,

Unfortunately, i have the same problem right now with CFD-Post
i cannot find what I have done wrong before. i appreciate if you could help me here. no one else has mentioned this error anywhere

Markus117 October 20, 2014 04:28

problem solved
I figured out, why this error message came up for me:

I loaded Fluent files which had the hash key (#) in their name. After renaming the files the error didn't show up. So check your files for any special characters.

gurjeet singh February 12, 2016 01:34

Application Error In CFD-post
I have done some simulations in fluent. after the completion i got results from result section. after that when i tried to save that results i found error of 'Application Error In CFD-post'. i am not able to understand what exactly its meaning. i am also confused that the results which i have got are correct or not. please help me related this error.

M.Shousha September 29, 2016 06:07

I've faced the same problem with the following error
"Ansys Workbench
Application Error in CFD-Post: ERROR 'wbload' action requires parameter: 'id'."

To solve this problem I saved the project without any special characters (Like; #@!&*$%^") in the address, as advised by "Markus117"


All times are GMT -4. The time now is 00:42.