|
[Sponsors] |
November 26, 2012, 03:23 |
2D pressure flotran to usable force
|
#1 |
New Member
Nederland
Join Date: Nov 2012
Posts: 3
Rep Power: 13 |
Hi there,
I'm just new with the flotran options in ansys and new with fluid dynamics. For a project i must calculate the drag and lift coefficient of a profile in ansys flotran. I made an 2D profile in ansys and solved it but i only can get the pressure on every node out of the solver. So it's a pressure without an area ? So now i must calculate the force for C=F/(rho*dens*V^2*A) I found a paper on google about this: link But in Figure 3B there's an formula FF=(Pi+Pi-1)/(2*abs(Yi-Yi-1)) that gives not the results that are mentioned in table. Can anyone explain me how this is calculated ? Because when i do this i don't have the same results as in the table. Or is there an other way to do this ? Thanks, jeffrey |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Pressure force calculation in incompressible solvers | philippose | OpenFOAM Running, Solving & CFD | 10 | December 7, 2019 04:51 |
FSI: Pressure and Normal Force don't match with expected values | Geraud | CFX | 6 | August 21, 2012 15:34 |
Setup/monitor points of pressure and force coefficients | siw | CFX | 3 | October 22, 2010 06:07 |
Ansys Flotran: Velocity or Pressure BC? | eu-ric thean | CFX | 2 | December 28, 2005 12:06 |
Calculate Pressure force | andreis | FLUENT | 0 | May 16, 2005 05:40 |