|
[Sponsors] |
porous-jump cannot be used in Eulerian multiphase flow? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 5, 2013, 11:43 |
porous-jump cannot be used in Eulerian multiphase flow?
|
#1 |
New Member
Join Date: Feb 2012
Posts: 13
Rep Power: 14 |
tested: Ansys 14.0 and 14.5
I'm setting up an internal face as porous-jump, and then when I choose the Eulerian multiphase model, it says "Warning: The porous-jump zone type is not valid with currently enabled models. Change zone type or enable appropriate models before proceeding". If I tried to use VOF or mixture model, then it will be OK. I'm wondering why is this incompatibility? Thanks~ |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mesh size in Eulerian multiphase flow - liquid/solid mixture | microfin | FLUENT | 4 | December 23, 2016 14:55 |
Multiphase flow (Eulerian) modeling | Umesh | FLUENT | 5 | December 29, 2014 11:06 |
multiphase flow in porous media | zhou | FLUENT | 2 | August 9, 2012 08:10 |
multiphase flow in porous media | reynolds039 | FLUENT | 0 | August 9, 2012 07:58 |
Modeling unsteady multiphase flow in porous media - convergence problem | Vaibhav Kumar | Main CFD Forum | 1 | July 22, 2012 05:32 |