Air Knife modelization -- CFD Online Discussion Forums

August 24, 2017, 03:13

Air Knife modelization

PipoZito

New Member

Join Date: Aug 2017

Posts: 1

Rep Power: 0

Hello Everyone,

I'm new to Ansys and Fluent and I'm trying to analyse an air knife model in fluent. (Air passing trough a tiny hole in 2D)
I've setup a mesh and tried to calculate the flow after the hole but my model diverge and I can't get any result.

I want to calculate for a 0,5mm hole but I also tried for a 10mm just to check the model.

You can find the geometry (10mm hole, 2D) enclosed.

Thank you very much for your help

Regards

Attached Images

Hole10mm.png (6.7 KB, 9 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Air entrainment model setup for spillway	oajor	FLOW-3D	4	November 17, 2016 12:02
Radiation interface	hinca	CFX	15	January 26, 2014 17:11
Simulation of air flow in a chamber	Issa	CFX	3	November 23, 2009 17:16
air bubble is disappear increasing time using vof	xujjun	CFX	9	June 9, 2009 07:59
Help!!!problems in air jet into water bath	kim	FLUENT	4	June 9, 2003 07:04

All times are GMT -4. The time now is 16:05.