|
[Sponsors] |
March 21, 2013, 07:09 |
CFX problem
|
#1 |
New Member
Join Date: Mar 2013
Posts: 1
Rep Power: 0 |
Hi there,
I am learning workbench by reading tutorial chapter 23 (link: https://www.sharcnet.ca/Software/Flu.../i1332347.html), after run the CFX solver, it showed An error has occurred in cfx5solve: | | | The ANSYS CFX solver could not be started, or exited with return | | code 255: . No results file has been created. I have checked reasons online but cannot understand what caused this problem, all I have done was following the tutorial. should anybody give me some suggestions on this? By the way, Is the definition file generated automatically? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ERROR #002100056 CFX FSI problem | Hongdao | CFX | 0 | November 10, 2010 03:58 |
CFX Mesh Deformation problem | Silmaril | CFX | 7 | October 19, 2010 10:00 |
CFX Casting problem: Can it be done all in one? | jfasl | CFX | 1 | September 14, 2010 03:14 |
Fan Modelling Problem in CFX | Jenny | CFX | 8 | September 11, 2007 13:59 |
CFX 4.4 installation problem | Pandu Sattvika | CFX | 1 | December 1, 2001 04:07 |