I have choose the inflation, but the inflations change in the first layers, but do no

hitzhwan · May 5, 2020, 10:24

I have choose the inflation, but the inflations change in the first layers, but do not change in the later , what is the reason, who can tell me ?

AtoHM · May 6, 2020, 01:13

What do you mean by "do not change in the later"?

hitzhwan · May 6, 2020, 11:06

Quote:

Originally Posted by AtoHM

What do you mean by "do not change in the later"?

You see the meshes under the red line I drew are all the inflations, but they do not grow according to the growth rate.

AtoHM · May 9, 2020, 04:05

I assume this is ansys meshing. I dont use that, so its just a guess but there might be a global setting for the boundary layers somewhere which overwrites the values you gave here?
I'm thinking like there might be a minimum layer height defined somewhere. Now if it starts from there and uses the growth ratio you specified, it reaches your specified max height earlier and its then constant for the upper layers?

hitzhwan · May 9, 2020, 09:55

Quote:

Originally Posted by AtoHM

I assume this is ansys meshing. I dont use that, so its just a guess but there might be a global setting for the boundary layers somewhere which overwrites the values you gave here?
I'm thinking like there might be a minimum layer height defined somewhere. Now if it starts from there and uses the growth ratio you specified, it reaches your specified max height earlier and its then constant for the upper layers?

You may mean the maximum layer height？ What do you use for meshing？

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
inflation layers for hexa mesh using icem cfd	Apple	CFX	4	January 6, 2012 00:12
Large Valve Flow Analysis - Inflation Problem	sercan85	ANSYS Meshing & Geometry	2	June 1, 2010 14:02
Inflation layers / boundary layer meshing.	andy2o	Main CFD Forum	3	February 22, 2009 09:03
Creating inflation layers for elbow with airfoil !	Aplus	CFX	1	March 13, 2006 22:22
Inflation	Gab	CFX	6	August 24, 2005 22:45

May 6, 2020, 01:13		#2
AtoHM Senior Member M Join Date: Dec 2017 Posts: 642 Rep Power: 12	What do you mean by "do not change in the later"?

May 9, 2020, 04:05		#4
AtoHM Senior Member M Join Date: Dec 2017 Posts: 642 Rep Power: 12	I assume this is ansys meshing. I dont use that, so its just a guess but there might be a global setting for the boundary layers somewhere which overwrites the values you gave here? I'm thinking like there might be a minimum layer height defined somewhere. Now if it starts from there and uses the growth ratio you specified, it reaches your specified max height earlier and its then constant for the upper layers?