|October 15, 2013, 10:00||
Join Date: Aug 2013
Posts: 37Rep Power: 5
I am working in a 3D wind rotor,modelled it in creo 2.0 and imported it to design modeller to draw the enclosure.I enclosed the rotor within a cylinder which again enclosed within a cuboid to give the boco's.
I did meshing in ansys mesh itself...but when I exported to fluent...it is not taxing the file,showing error as:
"Model information is incompatible with the incoming mesh"
I think it has got some problem with named selection...but I am totally blank regarding what could be done.
Plz I need help....thnx in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Star CCM Overset Mesh Error (Rotating Turbine)||thezack||CD-adapco||7||October 12, 2016 11:14|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|[ICEM] Missing face error from FLUENT even after repairing mesh + other questions||unknown159||ANSYS Meshing & Geometry||0||July 5, 2013 20:18|
|Inner geometry gets lost exporting mesh from ICEM CFD to CFX-Pre||powpow||CFX||3||December 20, 2012 10:14|
|snappyHexMesh won't work - zeros everywhere!||sc298||OpenFOAM Native Meshers: snappyHexMesh and Others||2||March 27, 2011 21:11|