 |
 |
 |
|
|
|
[Sponsors] | ||||
December 11, 2013, 18:42
|
Using cylindrical coordinate system
|
#1 |
|
New Member
Join Date: Dec 2013
Posts: 1
Rep Power: 0  |
Hello,
I've been modeling a cylindrical shell, by using cartesian system, and doing a transient analysis. My X-axis is the one passing by the center of my cylinder. When I create an analysis of the Y-component of displacement versus time by choosing an specific point (TimeHist Postprocessing), I got different results when I use the displacement on Z-component, still on the same point. What am I supposed to do to get equal results? Thanks in advance. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roe Flux Difference Splitting Scheme in Cylindrical Coordinate System | _inferno_ | Main CFD Forum | 0 | November 8, 2013 05:10 |
| Combination of cartesian and cylindrical coordinate system | Hermano | Main CFD Forum | 1 | November 30, 2011 22:07 |
| Cylindrical coordinate system - tangential velocity | alessio.nz | OpenFOAM | 2 | December 7, 2010 06:07 |
| change coordinate system cartesian to cylindrical | tht | FLUENT | 0 | September 6, 2007 06:46 |
| Multigrid method for cylindrical coordinate system | chinthakindi | Main CFD Forum | 5 | November 1, 2003 15:46 |
Linear Mode
