|
[Sponsors] |
May 3, 2014, 07:47 |
dynamic mesh
|
#1 |
New Member
mohamed eid mohamed
Join Date: May 2014
Posts: 1
Rep Power: 0 |
hello sir
I am trying to simulate a gas cylinder moving in tunnel has length 22 m .using dynamic meshing. to define regid body motion of the gas cylinder and I have assigned the air zone as deforming I am getting follow error .. Error: Update-Dynamic-Mesh failed. Negative cell volume detected. I tried smoothing the mesh, which does helps for a while. But the error repeats again and again. Please help me. Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Dynamic Mesh on Pintle type injector. | herntan | FLUENT | 16 | September 4, 2020 08:27 |
pls help. mesh collapsed with dynamic mesh. | wlt_1985 | FLUENT | 2 | May 7, 2020 10:42 |
[ICEM] Dynamic mesh setup with ICEM | David121284 | ANSYS Meshing & Geometry | 0 | April 11, 2014 04:19 |
Dynamic Mesh "Shadow Wall" | thezack | FLUENT | 0 | June 4, 2013 22:09 |
dynamic mesh for drop interface | IndrajitW | FLUENT | 0 | March 30, 2013 08:03 |