[FLUENT] Attempting to OGrid but Failing
2 Attachment(s)
Hello,
I am trying to run a simulation of fluid flow past a cylinder in the middle of a wind tunnel scenario. At this point, I have completed blocking and am beginning to mesh and refine these meshes. One of the ways I am refining the blocks is to implement an ogrid. Based on a tutorial for meshing around a car model, I have selected the blocks inside and below the cylinder in order to implement an ogrid. But, these attempts have failed with the error message "ogrid failed." Essentially, what am I doing wrong? Thank you, JEA |
All times are GMT -4. The time now is 21:11. |