Sweeping in Ansys

rsbabu2 · August 13, 2014, 16:50

I have created a geometry where I am sweeping a circle along a path in 3D. But, when the solid geometry is created after sweeping, the cross section is not a circle anymore. (Image attached) It seems to be ‘flatter’ and appears more like an oval / ellipse. I have attached my project. What am I doing wrong? I want it look like as if you took a long circular cylinder and ‘bent’ it along this 3D path.

Image can be accessed here: http://files.engineering.com/getfile...=StentRing.JPG

rsbabu2 · August 20, 2014, 09:30

Issue resolved.

August 13, 2014, 16:50	Sweeping in Ansys	#1
rsbabu2 New Member Join Date: Aug 2014 Posts: 4 Rep Power: 11	I have created a geometry where I am sweeping a circle along a path in 3D. But, when the solid geometry is created after sweeping, the cross section is not a circle anymore. (Image attached) It seems to be ‘flatter’ and appears more like an oval / ellipse. I have attached my project. What am I doing wrong? I want it look like as if you took a long circular cylinder and ‘bent’ it along this 3D path. Image can be accessed here: http://files.engineering.com/getfile...=StentRing.JPG

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Pro/E to ANSYS Parameterization Guide	Trues	ANSYS	4	April 18, 2018 05:52
Fluid structure interaction	jnattia	Main CFD Forum	25	May 21, 2015 09:16
Ansys HPC licensing policy	assafwei	ANSYS	0	June 29, 2014 16:00
Ansys workbench problem	Jonny6001	ANSYS	2	September 30, 2010 12:59
Exporting results from CFX to ANSYS ??	sohail ahmed	CFX	1	December 20, 2007 01:10

August 20, 2014, 09:30		#2
rsbabu2 New Member Join Date: Aug 2014 Posts: 4 Rep Power: 11	Issue resolved.