2D duct made in Solidworks, Analyse in FLUENT or CFX

cfdnoob · August 11, 2014, 16:57

So I made a complex 2D sketch of a duct in Solidworks.

And I want to import this into FLUENT/design modeler via workbench, but it says "No valid bodies found" and that is true because i just want the sketch from solidworks and import it into designmodeler, fluent or anything else so I can mesh it and maybe change its geometry.

It loads the solidworks file and other files (sldprt, igs, sat) into the workbench but I can't mesh it or open it in fluent or designmodeler and mesh it or anything else.....

Isn't there a way to just load the sketch file (.SLDPRT) and then put the mesh on it you like and then analyse it with either fluent or cfx.

stumpy · August 21, 2014, 09:36

You need to make a 2D body (surface) from the sketch in solidworks, then import that. You can't import just the sketch.

cfdnoob · August 25, 2014, 09:43

But there are two surfaces as the duct has a source in it

August 11, 2014, 16:57	2D Sketch made in Solidworks, Analysis in FLUENT or CFX	#1
cfdnoob New Member Rich Join Date: Jul 2014 Posts: 23 Rep Power: 11	So I made a complex 2D sketch of a duct in Solidworks. And I want to import this into FLUENT/design modeler via workbench, but it says "No valid bodies found" and that is true because i just want the sketch from solidworks and import it into designmodeler, fluent or anything else so I can mesh it and maybe change its geometry. It loads the solidworks file and other files (sldprt, igs, sat) into the workbench but I can't mesh it or open it in fluent or designmodeler and mesh it or anything else..... Isn't there a way to just load the sketch file (.SLDPRT) and then put the mesh on it you like and then analyse it with either fluent or cfx. Last edited by cfdnoob; August 12, 2014 at 14:20. Reason: simplified, better title

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Import definition file from cfx to fluent	lucky_m_m	ANSYS	0	May 15, 2013 06:04
diff between CFX & Fluent	Niru	CFX	1	November 6, 2012 17:14
Mesh and Solve Times for CFX, Fluent, CD-adapco	Jade M	Main CFD Forum	4	August 28, 2012 02:54
Solidworks model into Fluent...how to mesh?	cad2blender	FLUENT	1	August 12, 2012 13:10
Reynolds Stress model in CFX vs Fluent	Tim	CFX	1	October 7, 2009 06:19

August 21, 2014, 09:36		#2
stumpy Senior Member Join Date: Apr 2009 Posts: 531 Rep Power: 21	You need to make a 2D body (surface) from the sketch in solidworks, then import that. You can't import just the sketch.

August 25, 2014, 09:43		#3
cfdnoob New Member Rich Join Date: Jul 2014 Posts: 23 Rep Power: 11	But there are two surfaces as the duct has a source in it