|
[Sponsors] |
Saving Ansys Data in as a mat. file in Matlab |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 13, 2014, 12:46 |
Saving Ansys Data in as a mat. file in Matlab
|
#1 |
New Member
Niko
Join Date: Aug 2014
Posts: 3
Rep Power: 12 |
Hi,
I try to analyse a driller by getting information about the torsional stiffness, moments of inertia and a modal analysis! I would like to save the data in a mat. file in Matlab automatically! So Ansys determines all the information and sends it to matlab for saving it! Do I have to use APDL or can I also do it on another way? Thank you for your help! Kind regards Niko9310 |
|
Tags |
ansys, data saving, matlab |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to calculate mass flow rate on patches and summation of that during the run? | immortality | OpenFOAM Post-Processing | 104 | February 16, 2021 09:46 |
[Other] OpenFOAM Installation for navalFoam | sachinlb | OpenFOAM Community Contributions | 22 | July 28, 2017 06:26 |
Trouble compiling utilities using source-built OpenFOAM | Artur | OpenFOAM Programming & Development | 14 | October 29, 2013 11:59 |
[swak4Foam] swak4Foam-groovyBC build problem | zxj160 | OpenFOAM Community Contributions | 18 | July 30, 2013 14:14 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 15:00 |