 |
 |
 |
|
|
|
[Sponsors] | ||||
September 1, 2014, 09:23
|
How to remove bad quality cells?
|
#1 |
|
New Member
Join Date: Jul 2014
Posts: 22
Rep Power: 11  |
Hi
I have quite a lot of bad quality cells (resulting from o-grid etc). is there a way to improve them in this case? Last edited by kg1913; September 1, 2014 at 10:31. |
|
|
|
|
|
September 9, 2014, 23:42
|
|
#2 |
|
Member
Virendrasingh Pawar
Join Date: Jun 2013
Posts: 47
Rep Power: 12 |
Hi..i had similar problem once..turned out the blocking was incorrect and a hanging vertex was created giving high high aspect ratio cells...see if such is your case
|
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [snappyHexMesh] Number of cells in mesh don't match with size of cellLevel | colinB | OpenFOAM Meshing & Mesh Conversion | 14 | December 12, 2018 08:07 |
| Handling bad cells at the solver level | Akshay | OpenFOAM Running, Solving & CFD | 4 | June 18, 2014 01:35 |
| Mesh Quality good or bad? | RealENG22 | FLUENT | 5 | September 8, 2013 07:36 |
| [snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
| Problems of Duns Codes! | Martin J | Main CFD Forum | 8 | August 14, 2003 23:19 |
Linear Mode
