 |
 |
 |
|
|
|
[Sponsors] | ||||
September 24, 2014, 09:51
|
unselect overlapping area in some faces
|
#1 |
|
New Member
Join Date: Sep 2014
Posts: 1
Rep Power: 0  |
Dear all, I am a green hand for Ansys, now, I am doing static thermal simulation in Ansys workbench 14.5 and I need to apply convection on the outer surface of the structure.
The problem I met is about the overlapping faces. As for convection, only the outer surface is needed, but when I choosing the faces to assign convection, I can only choose the whole face including some area under another body while this area is not exposed to the air in practice. Do you have some tips to deal with it? |
|
|
|
|
 |
| Tags |
| ansys, convection, overlapping, thermal |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| decomposePar pointfield | flying | OpenFOAM Running, Solving & CFD | 28 | December 30, 2013 15:05 |
| Export area of faces | agustinvo | FLUENT | 0 | April 26, 2013 12:20 |
| DecomposePar unequal number of shared faces | maka | OpenFOAM Pre-Processing | 6 | August 12, 2010 09:01 |
| [blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
| Unaligned accesses on IA64 | andre | OpenFOAM | 5 | June 23, 2008 10:37 |
Linear Mode
