AQWA mesh error

deancarloz · December 10, 2014, 08:36

Hi guys, I`m trying to get Hydrostactic info of a Series 60 scaled model.
But everytime I`ve tried do so I get those error in the print.
I`ve tried different combinations of mesh, no luck so far.
Does anyone know what could be?

deancarloz · December 12, 2014, 13:56

anyone? ~:

CWTeebs · January 6, 2015, 15:35

Select "Ignore modeling rule violations" under Analysis settings. That's a warning about mesh quality, not a real error. As a rule of thumb if more than 10% of your panels violate those warnings than your mesh quality is probably too poor. Your mesh looks fine.

December 10, 2014, 08:36	AQWA mesh error	#1
deancarloz New Member Dean Zimmermann Join Date: Dec 2014 Posts: 7 Rep Power: 13	Hi guys, I`m trying to get Hydrostactic info of a Series 60 scaled model. But everytime I`ve tried do so I get those error in the print. I`ve tried different combinations of mesh, no luck so far. Does anyone know what could be?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
error compiling modified applications	yvyan	OpenFOAM Programming & Development	21	March 1, 2016 05:53
[swak4Foam] GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM Community Contributions	300	October 29, 2014 19:00
Compiling dynamicTopoFvMesh for OpenFOAM 2.1.x	Saxwax	OpenFOAM Installation	25	November 29, 2013 06:34
Errors in UDF	shashank312	Fluent UDF and Scheme Programming	6	May 30, 2013 21:30
Compile problem	ivanyao	OpenFOAM Running, Solving & CFD	1	October 12, 2012 10:31

December 12, 2014, 13:56		#2
deancarloz New Member Dean Zimmermann Join Date: Dec 2014 Posts: 7 Rep Power: 13	anyone? ~:

January 6, 2015, 15:35		#3
CWTeebs New Member Charlie Join Date: Dec 2014 Posts: 1 Rep Power: 0	Select "Ignore modeling rule violations" under Analysis settings. That's a warning about mesh quality, not a real error. As a rule of thumb if more than 10% of your panels violate those warnings than your mesh quality is probably too poor. Your mesh looks fine.