|
[Sponsors] |
January 18, 2015, 22:54 |
Extract points from polyline
|
#1 |
Member
S. Morichika
Join Date: Aug 2014
Posts: 62
Rep Power: 12 |
Hello Everybody,
I am trying to extract some points from the inlet surface of my geometry and for this, I draw a ployline on the inlet surface and save the points in a file. Everything is ok but when I used that point to release particle it seems some points are out of domain. Then I draw a polyline in the middle of the inlet surface and extract the point. But after run the simulation, it seems some points are out of domain. My question is, how can I get that points which are inside the domain. I will be happy to hear from you. Thanks and regards, Saeed |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
[snappyHexMesh] crash sHM | H25E | OpenFOAM Meshing & Mesh Conversion | 11 | November 10, 2014 12:27 |
[General] Extract Points along a polyline | AshwaniAssam | ParaView | 4 | May 1, 2014 15:09 |
CFD-Post: Polyline Export at Integration Points | minger | ANSYS | 4 | February 22, 2014 10:23 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 08:36 |