|
[Sponsors] |
February 3, 2015, 05:39 |
Rough Contacts in Workbench
|
#1 |
New Member
air
Join Date: Feb 2015
Posts: 1
Rep Power: 0 |
Hello everyone,
I am working on a simulation involving rough contacts in ansys workbench. This type of contact is similar to the bonded one, but when the stress reaches a certain limit it breaks. I need to set this limit load, but I am not able to find where I can set it. I have two volume of two different materials that are bonded if the stress is lower than a limit stress. Can anyone help me? Thank you very much in advance |
|
February 12, 2015, 05:20 |
|
#2 |
New Member
John Yu
Join Date: Dec 2014
Posts: 26
Rep Power: 12 |
You could set the type of contacts in the options window
Mechanical - Contacts Options.jpg |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ANSYS Workbench on "Uncertified" Linux Distros | hsr | CFX | 289 | April 20, 2023 10:23 |
CFX problems I got in Workbench | Anna Tian | CFX | 13 | July 3, 2017 02:49 |
FLUENT installation on UBUNTU 12.04 (LTS) | teymourj | FLUENT | 2 | March 1, 2017 23:24 |
Remeshing with INTEGRATED Workbench | bertozzi_marco | CFX | 0 | December 21, 2014 08:49 |
Question on running CFX simulations in workbench parameter set table | Anna Tian | CFX | 0 | September 20, 2014 02:51 |