|
[Sponsors] |
Polyflow. The problem Preprocessors does not converge. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 20, 2015, 07:40 |
Polyflow. The problem Preprocessors does not converge.
|
#1 |
New Member
Estitxu
Join Date: Feb 2015
Posts: 1
Rep Power: 0 |
Good Morning Polyflow users,
I keep getting this error message from Polyflow: "The problem Preprocessors does not converge because there are not enough iterations. The expert system suggests to change the maximum number of iterations from 50 to 68" My question is, where is this menu, "number of iterations"? The only reference to number of iterations I've managed to find is under Numerical Parameters ->Modify numerical parameters for iterations -> Modify the max number of iterations. Here, I've already set the value up to 300 and I keep getting the same message. Any suggestions? Thanks very much. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mixture model problem - could someone please advise? | matlab_monkey | FLUENT | 2 | July 26, 2012 09:20 |
Converge problem for unsteady gas solid flow | kongl1986 | FLUENT | 5 | March 1, 2012 17:31 |
CFX converge problem caused by shock waves | littlelz | CFX | 3 | August 17, 2009 10:35 |
converge problem | snowshovel | CFX | 13 | January 18, 2007 22:05 |
Converge Problem | Jen | FLUENT | 11 | January 28, 2005 15:20 |