Problem with automatical mesh in ICEM
 

Hi everyone,
I have a geometry portion of a francis turbine runner.
When i try to mesh it i get meshed only a pice of this portion (image below).
I have tried whatever i knew but always happen the same.
Could someone help me?

Many thanks

You tried to unite them into a single geometric. That is the beginning geometry
trying as shown below (image below)

before
http://i.imgur.com/E7VQsMB.jpg

after
http://i.imgur.com/BmS7vkk.jpg

maybe help you

Many thanks Green52. I have ben studying this problem with other shapes and I have realised that this only happens when I import Geometries into an other one or when I transform them (rotate,...).
Im sure is because of u have told me. I will try to find a solution about how to unite both geometries in one solid.

Thanks again :)

with pleasure, anytime with pleasure :)