 |
 |
 |
|
|
|
[Sponsors] | ||||
September 16, 2015, 05:50
|
screw compressor
|
#1 |
|
New Member
suhag patel
Join Date: Sep 2015
Posts: 3
Rep Power: 10  |
hii ,
i found problem in doing cfd analysis of screw compressor , is there any right way to simulate it??? Last edited by suhagpatel; September 26, 2015 at 02:30. |
|
|
|
|
|
September 26, 2015, 02:38
|
|
#2 |
|
New Member
suhag patel
Join Date: Sep 2015
Posts: 3
Rep Power: 10 |
hii,
I am doing analysis of screw compressor and want take male and female rotor solid but I dont want to involve them in meshing and further computation process. so please suggest any way to freeze/deactivate it. please suggest it as early as possible. |
|
|
|
|
|
|
February 8, 2016, 00:16
|
cylinder
|
#3 |
|
New Member
suhag patel
Join Date: Sep 2015
Posts: 3
Rep Power: 10 |
hii,
I am simulating flow between two concentric cylinder with inner cylinder rotating using dynamic mesh model. I have few doubt which method of re-meshing is best? |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Screw compressor - How? | Roland R | CFX | 4 | April 10, 2018 02:52 |
| Screw Compressor | Rohit Tripathy | FLUENT | 0 | May 5, 2013 07:00 |
| Turbocharger Compressor Wheel CFD Analysis | aymen_a22 | ANSYS | 1 | April 20, 2013 10:39 |
| [TurboGrid] Turbocharger Compressor Wheel Meshing | aymen_a22 | ANSYS Meshing & Geometry | 0 | March 20, 2013 10:27 |
| Compressor Blade Analysis in Ansys CFX | LynchMobster47 | Main CFD Forum | 0 | April 10, 2012 22:43 |
Linear Mode
