 |
 |
 |
|
|
|
[Sponsors] | ||||
February 26, 2016, 03:48
|
Could you assess my residual graph?
|
#1 |
|
New Member
Jongmin Choi
Join Date: Jan 2016
Posts: 14
Rep Power: 12  |
Hi, I'm simulating Carotid artery using ANSYS Fluent. It's transient cfd model.
Fortunatelly, I 've finally gotton this residual graph, However I coulnd't be sure that this is acceptable or not. Could you give me any comments about this residuals? Do I have to modify some factors? Thank you 
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| simpleFoam error - "Floating point exception" | mbcx4jc2 | OpenFOAM Running, Solving & CFD | 12 | August 4, 2015 03:20 |
| Unstabil Simulation with chtMultiRegionFoam | mbay101 | OpenFOAM Running, Solving & CFD | 13 | December 28, 2013 14:12 |
| pimpleFoam: turbulence->correct(); is not executed when using residualControl | hfs | OpenFOAM Running, Solving & CFD | 3 | October 29, 2013 09:35 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 07:37 |
| Orifice Plate with a fully developed flow - Problems with convergence | jonmec | OpenFOAM Running, Solving & CFD | 3 | July 28, 2011 06:24 |
Linear Mode
