3D wing meshing issues on inlet (ICEM) -- CFD Online Discussion Forums

May 5, 2020, 03:22

3D wing meshing issues on inlet (ICEM)

sakibrah

New Member

Sakib Rahman

Join Date: Apr 2020

Posts: 1

Rep Power: 0

Dear All,

I am currently trying to mesh a 3D S809 profile blade. It is 0.1 m spanwise only as I am limited to 512,000 cells. However I can't seem to get a mesh in the spanwise direction on my inlet, there are 30 nodes along the spanwise direction (the semi-circular and upper/lower wall area). I can however, get spanwise nodes along my outlet and blade. I know this is probably an association issue but I can't seem to figure it out. Photos are attached for reference.

I appreciate any help.

Sincerely,
Sakib.

Attached Images

	MESH PIC 1.jpg (139.3 KB, 6 views)
	MESH PIC 2.jpg (125.8 KB, 7 views)
	MESH PIC 3.jpg (169.3 KB, 6 views)
	MESH PIC 4.jpg (89.6 KB, 4 views)

Last edited by sakibrah; May 5, 2020 at 03:28. Reason: additional left out information

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
3D Airfoil ICEM Hexa Meshing Skewness Issues	AamirSultan	Mesh Generation & Pre-Processing	0	December 1, 2018 16:16
[ANSYS Meshing] ICEM Meshing issues	Hnsie813	ANSYS Meshing & Geometry	1	October 19, 2018 04:54
issues when using nonuniform List at inlet	haow	OpenFOAM Pre-Processing	0	July 2, 2018 13:33
[ICEM] Meshing Issues in ICEM	amod_kumar	ANSYS Meshing & Geometry	4	June 23, 2010 07:57
[ICEM] Meshing Issues in ICEM	amod_kumar	ANSYS Meshing & Geometry	1	June 21, 2010 11:26

All times are GMT -4. The time now is 01:35.