|
[Sponsors] |
June 4, 2016, 06:04 |
Adding Ansys Maxwell component in Simplorer
|
#1 |
New Member
srijan.rio
Join Date: May 2016
Posts: 10
Rep Power: 10 |
Hi everyone. I am using Ansys Simplorer and Maxwell v 15. While adding a Maxwell Dynamic Magnetostatic Component from Maxwell, the terminals in the Simplorer circuit s naming is changing( T1, T2, T3 .. etc). Is there any way to know which terminals in Simplorer correspond to which in the Maxwell.
Kindly help if anyone knows about this |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys Maxwell Simplorer transient cosimulation | srijan.rio | ANSYS | 1 | November 15, 2016 16:18 |
chtMultiRegionSimpleFoam | samiam1000 | OpenFOAM Running, Solving & CFD | 39 | March 31, 2016 09:43 |
chtMultiRegionSimpleFoam: strange error | samiam1000 | OpenFOAM Running, Solving & CFD | 26 | December 29, 2015 23:14 |
Help with chtMultiRegionFoam | jbvw96 | OpenFOAM Running, Solving & CFD | 2 | December 26, 2010 18:16 |