|
[Sponsors] |
December 7, 2021, 10:18 |
Temperature limited to problem.
|
#1 |
New Member
Gaurav Kumar
Join Date: Jan 2018
Location: Delhi
Posts: 17
Rep Power: 8 |
Hi everyone,
I am simulating a pipe flow system with inlet temperature and mass flow water with properties changing with temperature. I have made udf for properties. Pipe have a central rod in it where it is generating a constant heat flux in the inner boundary wall of rod. Flow is flowing with a constant pressure of 25 MPa.. When I start the calculations, after 10-15 iterations it is showing temperature limited to..problem with higher limit to some cells and lower limit to some cells... I am monitoring the volume average temperatures of rod. It is increasing and not remain constant.. The other residuals are converged. In post processing the temperature profile of rod is very absurd, with high values of temperature upto 1000 deg Celsius, while it should be around 450-500 deg Celsius. What should I do?? |
|
December 7, 2021, 12:48 |
|
#2 |
Senior Member
Erik
Join Date: Feb 2011
Location: Earth (Land portion)
Posts: 1,167
Rep Power: 23 |
Check your material properties and inlet/outlet flows and temps and energy balances.
Try using standard constant property water to see if material properties are incorrect. |
|
December 12, 2021, 07:38 |
|
#3 |
New Member
Gaurav Kumar
Join Date: Jan 2018
Location: Delhi
Posts: 17
Rep Power: 8 |
Thanks for the reply, I have checked everything but still it is giving the same problem
|
|
December 27, 2021, 01:03 |
|
#4 |
New Member
Join Date: Jun 2021
Posts: 13
Rep Power: 4 |
Did you try to run the simulation without UDF?
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Mesh& steptime independant: conduction-convection problem | Fati1 | Main CFD Forum | 1 | October 28, 2018 13:52 |
problem in temperature and liquid fraction value in the udf | durg | FLUENT | 0 | October 23, 2018 01:52 |
the problem that gradually change of temperature contour in coal gasification | bluenail | FLUENT | 0 | November 10, 2014 02:41 |
UDF for Back-flow Temperature | G340 | Fluent UDF and Scheme Programming | 3 | August 21, 2013 04:56 |
Problem when adding temperature to interFoam | houkensjtu | OpenFOAM | 4 | November 5, 2012 02:35 |