[dadouxx]

Hi !

I am new in ANSYS and I am trying to simulate a contact between 2 parts.
You can fin attached my model. The two parts are separated (2 solids). And I would like the upper part fits the bottom part, to get the same shape. However, I don't manage to do it. I still have the same error "contact status has experienced an abrupt change ansys".
I tried to fix the bottom part (non-deformable) and to apply force on the upper part but I am not sure it is the good way to do. Do you have some ideas about how to do it ? Which boundary conditions should I use ?

Thanks for your help !