 |
 |
 |
|
|
|
[Sponsors] | ||||
July 13, 2016, 08:07
|
Reference values for drag coefficient
|
#1 |
|
New Member
Marcos
Join Date: Nov 2013
Posts: 12
Rep Power: 12  |
Hello,
I am trying to simulate the flow of a non-Newtonian power law fluid past a sphere. On the Reference Values, what should I use for the viscosity box? Should I put the same value of the consistency index? Thank you very much. |
|
|
|
|
 |
| Tags |
| drag coefficient, fluent 14 to fluent 15., power law fluid |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Setting the height of the stream in the free channel | kevinmccartin | CFX | 12 | October 13, 2022 21:43 |
| Simulation of a single bubble with a VOF-method | Suzzn | CFX | 21 | January 29, 2018 00:58 |
| OpenFoam-1.7.x on Suse 11.2 (64bit) does not compile | val46 | OpenFOAM Installation | 4 | August 27, 2010 03:43 |
| OpenFOAM on MinGW crosscompiler hosted on Linux | allenzhao | OpenFOAM Installation | 127 | January 30, 2009 19:08 |
| Automotive test case | vinz | OpenFOAM Running, Solving & CFD | 98 | October 27, 2008 08:43 |
Linear Mode
