 |
 |
 |
|
|
|
[Sponsors] | ||||
December 21, 2016, 08:47
|
Negative mass flow rate
|
#1 |
|
New Member
Join Date: Mar 2016
Posts: 2
Rep Power: 0  |
Hello all, im trying to model port flow simulation of an engine to get the mass flow rate across the inlet valve. the problem is that the mass flow rate gets a negative value. ive tried to increase the pressure difference but it still also gives a negative result.
|
|
|
|
|
|
December 23, 2016, 08:50
|
|
#2 |
|
Senior Member
Anonymous
Join Date: Dec 2011
Location: USA
Posts: 108
Rep Power: 14 |
Are you sure the negative isn't denoting the direction of flow?
|
|
|
|
|
|
 |
| Tags |
| flow, inlet, mass, negative, rate |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
| Specify mass flow rate for periodic boundary conditions in channel flow | lion1990 | OpenFOAM Running, Solving & CFD | 1 | July 9, 2018 17:46 |
| Uniform mass flow rate at different outlets. | mehcaecfd | STAR-CCM+ | 6 | May 18, 2016 02:34 |
| Mass Flow Rate is not converging | destgir448 | CFX | 5 | December 11, 2010 05:55 |
| [blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
Linear Mode
