 |
 |
 |
|
|
|
[Sponsors] | ||||
February 20, 2017, 07:38
|
ANSYS 17.1, using Elbow290 elements
|
#1 |
|
New Member
anon
Join Date: Feb 2017
Posts: 1
Rep Power: 0  |
I am modelling different pipe geometries and comparing each using solid, shell and elbow 290 elements. I am unsure how to actually mesh a geometry using elbow 290 elements. I know for shell you use the mid-surface tool but i am stuck trying to use elbow elements. Any help/feedback greatly appreciated. Note - I know this be very simple but ive spent an awful lot of time banging my head against a wall here
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3D Windturbine simulation in SU2 | k.vimalakanthan | SU2 | 15 | October 12, 2023 05:53 |
| Command Line Run for ANSYS | Liaquat | ANSYS | 11 | April 19, 2018 09:49 |
| [ANSYS Meshing] Export meshed part in ICEM to ANSYS APDL | Alam Swift | ANSYS Meshing & Geometry | 0 | May 21, 2016 08:04 |
| Average frictional stress on surface weighted by elements area (Ansys Workbench Mech) | Giulio89 | Structural Mechanics | 0 | July 8, 2013 09:44 |
| Ansys hang subtracting volumes | Aco1000 | ANSYS | 0 | July 14, 2010 08:57 |
Linear Mode
