 |
 |
 |
|
|
|
[Sponsors] | ||||
March 18, 2017, 13:07
|
Bolt Pretension Problem
|
#1 |
|
New Member
Nima
Join Date: Mar 2017
Posts: 1
Rep Power: 0  |
Hello All,
I have a bolt as a simple cylinder and a nut at the bottom. I am trying to apply a pretension load on 1 face of bolt, but for some reasons when i press apply for geometry selection, the software doesn't select the surface (the surface does not turn into red with compression load arrow). does this problem have to do with my model design? any help or advice is really appreciated. Thanks |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] engineFoam new mesh problem | ayhan515 | OpenFOAM Meshing & Mesh Conversion | 5 | August 10, 2015 08:45 |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 04:43 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 05:59 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |
Linear Mode
