|
[Sponsors] |
The bounding box evaluation for the contours failed |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 12, 2017, 07:13 |
The bounding box evaluation for the contours failed
|
#1 |
New Member
Join Date: Feb 2017
Location: UK
Posts: 3
Rep Power: 9 |
Hi All,
I am trying to make a flowpath for a compressor on Design modeler. After having made the scketches for hub, shroud, inlet and outlet and made sure that the common point are coincident, I got then the following error message: Error: An internal error has occurred. The bounding box evaluation for the contours failed. Do you have any ideas of what is happening? Regards |
|
May 12, 2017, 12:15 |
|
#2 |
New Member
Join Date: Nov 2010
Posts: 10
Rep Power: 15 |
hi have you solved this?, i have the same problem.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foam::error::printStack(Foam::Ostream&) with simpleFoam -parallel | U.Golling | OpenFOAM Running, Solving & CFD | 52 | September 23, 2023 03:35 |
Initial conditions for uniform flow | andreas | OpenFOAM | 5 | November 16, 2012 15:00 |
[OpenFOAM] ParaView/Parafoam error when making animation | Disco_Caine | ParaView | 6 | September 28, 2010 09:54 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |
user defined function | cfduser | CFX | 0 | April 29, 2006 10:58 |