Swirl fraction or swirl degree, please help me

Emily_emi · April 19, 2017, 05:03

Dear all,
I am trying to follow a paper about spray drying and air flow simulation then I am trying to get a same result with the paper. The flow of in a spray dryer is turbulent and two-phase (air and droplet). K-e(realizable and standard wall function) model have been using for turbulence. In the discrete phase model DPM, injection type is a cone, then I defined cone injection with Rosin Rammler distribution method. There is a parameter which is swirl fraction. Do I have to define this? Paper given me swirl degree is 5 degree and water velocity is 49m/s. I little confused with this two parameters. Should i find it? Where i could define swirl degree, what is swirl degree. Is it important?
Thank you so much,

Emily_emi · April 19, 2017, 05:08

https://www.researchgate.net/publica...nt_spray_dryer

April 19, 2017, 05:03	Swirl fraction or swirl degree, please help me	#1
Emily_emi New Member Emily Join Date: Oct 2016 Location: Taiwan Posts: 4 Rep Power: 11	Dear all, I am trying to follow a paper about spray drying and air flow simulation then I am trying to get a same result with the paper. The flow of in a spray dryer is turbulent and two-phase (air and droplet). K-e(realizable and standard wall function) model have been using for turbulence. In the discrete phase model DPM, injection type is a cone, then I defined cone injection with Rosin Rammler distribution method. There is a parameter which is swirl fraction. Do I have to define this? Paper given me swirl degree is 5 degree and water velocity is 49m/s. I little confused with this two parameters. Should i find it? Where i could define swirl degree, what is swirl degree. Is it important? Thank you so much,

April 19, 2017, 05:08	Paper survey	#2
Emily_emi New Member Emily Join Date: Oct 2016 Location: Taiwan Posts: 4 Rep Power: 11	https://www.researchgate.net/publica...nt_spray_dryer

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
multiphaseEulerFoam (OF2.3.0) : Courant number explodes when running in parallel	Mehrez	OpenFOAM Running, Solving & CFD	10	May 18, 2016 12:44
Problem of simulating of small droplet with radius of 2mm	liguifan	OpenFOAM Running, Solving & CFD	5	June 3, 2014 03:53
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 04:32
On the damBreak4phaseFine cases	paean	OpenFOAM Running, Solving & CFD	0	November 14, 2008 22:14
CFX Solver Memory Error	mike	CFX	1	March 19, 2008 08:22