 |
 |
 |
|
|
|
[Sponsors] | ||||
June 20, 2017, 15:03
|
Revolute joint in 2D?
|
#1 |
|
New Member
Khan
Join Date: Jan 2017
Posts: 18
Rep Power: 11  |
Hi there,
I was wondering how to make a body-to-body revolute joint in 2D. When I define the geometry analysis type as "2D", this revolute joint is not available. I can make this revolute joint in 3D, but I want to use 2D instead of 3D in order to reduce my simulation time. Is there any way to make a revolute joint in 2D? I would appreciate any inputs! Thank you for your valuable time. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| glued joint | probx | Structural Mechanics | 0 | May 9, 2017 09:15 |
| Problem in bipolar hip joint simulation | rifz01 | Structural Mechanics | 0 | February 15, 2017 20:08 |
| Revolute joint in 2D? | khhan0543 | ANSYS | 0 | February 2, 2017 15:58 |
| About joint face in implicit method | quaintchewster | Main CFD Forum | 0 | November 11, 2010 08:04 |
| [ICEM] connected mesh in blocks joint | gajemon | ANSYS Meshing & Geometry | 6 | December 17, 2009 17:31 |
Linear Mode
