Home > Forums > Software User Forums > ANSYS

Simulation of boundary layer thickness

Mark Forums Read

Reply

Search this Thread

September 6, 2017, 03:57	Simulation of boundary layer thickness	#1
Jagdesh New Member jagdesh kumar patkar Join Date: Jul 2017 Posts: 2 Rep Power: 0	I am simulating boundary layer thickness of flat plate. In that i am getting velocity greater than the free stream velocity, which is not what Blasius profile of boundary layer is. My free stream velocity is 1 m/s. Boundary conditions are: Inlet : velocity inlet Outlet : pressure outlet Bottom : No slip for flat plate Top : v=0 and u=1 m/s

Reply

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind turbine simulation	Saturn	CFX	60	July 17, 2024 05:45
y+ = 1 boundary layer mesh with snappyHexMesh	Arzed23	OpenFOAM Running, Solving & CFD	6	November 23, 2022 15:15
Centrifugal fan	j0hnny	CFX	13	October 1, 2019 13:55
Validity & transformation of boundary layer equations	Obad	Main CFD Forum	2	April 27, 2015 02:59
Wall coordinates and boundary layer thickness	bentmol	Main CFD Forum	1	July 3, 2011 20:44

All times are GMT -4. The time now is 00:56.