3D-1D interactive coupling b/w workbench and matlab
 

Hello forum!

I am working on a multi-scale modeling project of a pipe network. I have working 3D two way FSI model on ansys workbench and a reduced 1D model code on matlab.

I am trying to set up an interface b/w models to pass output average parameters from 1D to 3D as input condition. Is there a way to link matlab and ansys for doing so?

I have tried following instructions mentioned on this page http://www.ansys-blog.com/how-to-mak...pps-for-ansys/. But no luck as I couldn't get it to work.

Please let me know!

Hi,

Make sure that -aas is added in the command line of ANSYS command, or as an additional parameter if you are using the ANSYS launcher

Sorin

Sure. Will try this Sorin. Thanks!

Let me know if it worked for you.

Sorin