 |
 |
 |
|
|
|
[Sponsors] | ||||
Turbulence variables only occurring at inlets |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 12, 2017, 10:41
|
Turbulence variables only occurring at inlets
|
#1 |
|
New Member
Michael
Join Date: May 2017
Posts: 12
Rep Power: 10  |
Hi all,
I am trying to model the fluid film in a journal bearing in CFD. The bearing is a two pad bearing that is fully flooded. I am trying to include turbulence in my model. I am using the k-omega SST model. I have created models in both CFX and in Fluent. I have run the model and varying rotor speeds in order to get the turbulent model to work. This has resulted in Reynolds numbers ranging from 200-20000+. I have y+ values in the range from 0.1-0.8. The model is always resulting in turbulent variables occurring at the inlet but then dropping off instantly and being constant across the rest of the film. |
|
|
|
|
|
| Tags |
| cfx, fluent, turbulence |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how to set URANS turbulence model in unsteady flow simulation | TimLiu | OpenFOAM Pre-Processing | 0 | April 25, 2017 09:52 |
| Turbulence postprocessing | Mohsin | FLUENT | 2 | October 3, 2016 15:18 |
| Question on Turbulence Intensity | Eric | FLUENT | 1 | March 7, 2012 05:30 |
| UDF to calculate phase-averaged turbulence variables in a periodic flow | ShuangqingXu | Fluent UDF and Scheme Programming | 0 | October 27, 2011 00:48 |
| turbulence modeling questions | llowen | Main CFD Forum | 3 | September 11, 1998 05:24 |
Linear Mode
