|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Arthur Adeodato
Join Date: Oct 2017
Posts: 1
Rep Power: 0 ![]() |
Dear all,
I am studying in the programing mode and I have a line witch must be modeled as a Beam element. However, only the 2 nodes of the extremity are able to rotations in Z. All others nodes inside the line must not have relative moviment of rotations between thenselfs. How to make it in programing mode ??? Thanks a lot, Arthur. |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] 3D Mesh conversion from gmsh-2.5.0 to OpenFOAM | Ancioi | OpenFOAM Meshing & Mesh Conversion | 17 | January 9, 2019 00:50 |
[ANSYS Meshing] Error in Workbench "Unable to attach to geometry file" | Jeremie84 | ANSYS Meshing & Geometry | 70 | October 25, 2017 17:03 |
Ansys Workbench Beam & Shell element | Andone | Structural Mechanics | 4 | September 19, 2017 07:52 |
[Other] Mesh Importing Problem | cuteapathy | ANSYS Meshing & Geometry | 2 | June 24, 2017 06:29 |
Stress analysis of a clamped beam | cvasse | OpenFOAM Running, Solving & CFD | 0 | April 24, 2017 08:44 |