error related to meshing -- CFD Online Discussion Forums

November 24, 2017, 05:29	error related to meshing	#1
sijusimon New Member Siju simon Join Date: Nov 2017 Posts: 18 Rep Power: 8	I Made a model of reinforced concrete beam column joint in ansys workbench. while solving the model, after giving all force and boundary condition, it shows following two errors: error 1: "The value of UZ at node 5073 is 6057083.95. It is greater than the current limit of 1000000" error 2: "If one or more parts of the model are held together only by contact verify that the contact surfaces are closed. Also make sure that there are constraints (or friction) in the sliding direction even if no load is applied in that direction" how can i rectify these errors

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ANSYS Meshing] only automatic meshing works,	kazra	ANSYS Meshing & Geometry	2	February 23, 2017 11:38
[Gmsh] 3D coil mesh: can't create the volume?	RomainBou	OpenFOAM Meshing & Mesh Conversion	3	July 18, 2016 05:09
[Gmsh] Vertex numbering is dense	KateEisenhower	OpenFOAM Meshing & Mesh Conversion	7	August 3, 2015 10:49
[ANSYS Meshing] Icem meshing queries	Mfaizan	ANSYS Meshing & Geometry	21	July 30, 2015 23:10

All times are GMT -4. The time now is 16:18.