Ansys Workbench Cubic Mesh -- CFD Online Discussion Forums

January 5, 2018, 13:01

Ansys Workbench Cubic Mesh

germanlee

New Member

Join Date: Jan 2018

Posts: 1

Rep Power: 0

I have this cubic scaffold with pores inside and I'm not sure what I can do to increase mesh quality,been getting red bits around the pores.Maybe some problems with my geometry as well?

Thanks.

Attached Images

Capture2.jpg (138.7 KB, 6 views)

Tags

ansys workbench, cubic, mesh, pores

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
transfer mesh from ansys workbench to maxwell	davidsve	ANSYS	2	June 11, 2018 04:42
[Commercial meshers] Problems with ANSYS mesh conversion	tdog	OpenFOAM Meshing & Mesh Conversion	1	March 31, 2016 18:36
[Workbench] Ansys Workbench mesh problem	engeagle	ANSYS Meshing & Geometry	0	March 21, 2016 11:22
importing mesh from Gambit and other software to ansys workbench	mortazavi	ANSYS Meshing & Geometry	5	June 6, 2011 12:09
Ansys workbench CFX Mesh	Tom	ANSYS Meshing & Geometry	22	December 1, 2010 22:34

All times are GMT -4. The time now is 00:00.