 |
 |
 |
|
|
|
[Sponsors] | ||||
January 11, 2018, 09:20
|
ICEM CFD: Concentric cylinder
|
#1 |
|
Member
HARIHARAN K
Join Date: Oct 2014
Posts: 40
Rep Power: 13  |
Hi everyone,
I am new to ICEM CFD and trying to learn it. I have done a few tutorials and to test my own understanding, I created a concentric cylinder and tried to mesh it. I was able to complete it but when I tried to export the mesh to Fluent, it showed an error message. I have attached the images. Any idea why the error message is popping up? Is it because it is of low quality? Thank you. |
|
|
|
|
|
January 11, 2018, 22:00
|
|
#2 |
|
Member
HARIHARAN K
Join Date: Oct 2014
Posts: 40
Rep Power: 13 |
I removed the biasing of radial direction near the outer surface and the problem is solved!
I am able to import to Fluent now and shows good quality too! No idea why it happens though! |
|
|
|
|
|
 |
| Tags |
| ansys, export, fluent, icem cfd, meshing |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Meshing inclined cylinder with PBC tetra mesh ICEM | shashi_soman | ANSYS Meshing & Geometry | 0 | September 26, 2015 19:27 |
| Meshing inclined cylinder with PBC tetra mesh ICEM | shashi_soman | Mesh Generation & Pre-Processing | 1 | September 26, 2015 19:05 |
| Learn ANSYS ICEM CFD | easy_astronaut | ANSYS | 2 | December 15, 2013 16:34 |
| [ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent | ivanddd | ANSYS Meshing & Geometry | 1 | February 3, 2011 01:51 |
| Where do we go from here? CFD in 2001 | John C. Chien | Main CFD Forum | 36 | January 24, 2001 22:10 |
Linear Mode
