 |
 |
 |
|
|
|
[Sponsors] | ||||
February 19, 2018, 12:19
|
Extracting 2D blade profile using BladeGen
|
#1 |
|
New Member
Louis
Join Date: Feb 2018
Posts: 2
Rep Power: 0  |
Hi,
I'm designing a micro-turbine, and was wondering if there is any way to extract the 2D profiles at hub, midspan and tip of a blade created in BladeGen such that they can be used for 2D simulations in Fluent. Any suggestions are appreciated. |
|
|
|
|
 |
| Tags |
| 2d profile, ansys, bladegen, fluent |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] Change an existing blade geometry with bladegen | gdimitris | ANSYS Meshing & Geometry | 0 | June 28, 2017 21:24 |
| bladegen with blade coordinates | Faizully | CFX | 0 | November 18, 2015 08:46 |
| Blade Generator: How to use Design Profile & Trim Profile | Stabum | CFX | 2 | July 31, 2015 14:01 |
| Creatingfan blade profile in GAMBIT | Jenny | FLUENT | 5 | April 28, 2005 06:52 |
| bladegen & NACA profile | ichgut | CFX | 1 | August 9, 2004 10:31 |
Linear Mode
